Web of Conferences
Advanced Search
Home ESOMAT 2009 - 8th European Symposium on Martensitic Transformations Article
Free access article

Issue ESOMAT 2009
2009
Article Number 02006
Number of page(s) 8
Section Principles, Simulations, Materials: Background
DOI http://dx.doi.org/10.1051/esomat/200902006
Published online 01 September 2009

ESOMAT 2009, 02006 (2009)
DOI: 10.1051/esomat/200902006

R-phase stabilization in ultra-fine grain NiTi wires after mechanical cycling

A. Condó1, Ch. Somsen2, J. Olbricht2, G. Eggeler2 and A. Dlouhý3

1  Centro Atómico Bariloche, Av. Bustillo 9.500, 8400 S.C. de Bariloche, Argentina
2  Ruhr-Universität Bochum, Institut für Werkstoffe, Universitätsstr. 150, 44801 Bochum, Germany
3  Academy of Sciences CR, Institute of Physics of Materials, Zizkova 22, 616 62 Brno, Czech Republic

dlouhy@ipm.cz

Published online: 1 September 2009

Abstract
Loading-unloading cycles were applied in order to induce forward and reverse martensitic transformations B2 <-> (R) <-> B19’ in ultra-fine grained NiTi (50.9 at% Ni) wires. Stress-strain hysteresis loops change with increasing number of cycles. It has been observed that the upper plateau stress, which corresponds to the forward transformation induced in the loading part of the cycle, decreases considerably during mechanical cycling. In contrast, an only moderate drop of the lower plateau stresses characterizes the reverse transformation before the hysteresis loops reach their saturated shape. Moreover, a permanent plastic strain of the order of 1% accumulates before the hysteresis loops saturate. An extensive transmission electron microscopy investigation on the nano-grain scale has been performed in the present study in order to account for the observed hysteresis loop evolution. A representative sample of the selected area diffraction (SAD) rings was evaluated for both, the as received state of the wire before the fatigue experiment and the mechanically cycled material. Results of the SAD analysis suggest that the loading cycles stabilize the R phase. However, no evidence was found for retained B19’ phase after cyclic loading. Some consequences of these microstructural findings are discussed.



© Owned by the authors, published by EDP Sciences 2009


What is OpenURL?

The OpenURL standard is a protocol for transmission of metadata describing the resource that you wish to access. An OpenURL link contains article metadata and directs it to the OpenURL server of your choice. The OpenURL server can provide access to the resource and also offer complementary services (specific search engine, export of references...). The OpenURL link can be generated by different means.
  • If your librarian has set up your subscription with an OpenURL resolver, OpenURL links appear automatically on the abstract pages.
  • You can define your own OpenURL resolver with your EDPS Account. In this case your choice will be given priority over that of your library.
  • You can use an add-on for your browser (Firefox or I.E.) to display OpenURL links on a page (see http://www.openly.com/openurlref/). You should disable this module if you wish to use the OpenURL server that you or your library have defined.